HOMCOM 823-006V70 Manual Del Usuario página 20

5.4 SETTINGS
5.4.1.
Start-up and Shutdown
Press POWER to turn the unit on.
The unit runs in in FAN as default.
Press MODE button to select the desired operation mode.
Press POWER again to turn off the power.
5.4.2.
Operation mode
The unit has five operation modes: Cool, heat, fan, dry,sleep（

Sleep mode is only optional on the remote control）
A. Cooling your room
Select the cool mode to lower the temperature in your room.
Press MODE button repeatedly until the LED of COOL operation lights up.
Press ADD/MINUS button to adjust the temperature which is displayed on
the screen. The temperature can be set between 16℃ and 32℃.
Press SPEED button repeatedly until the desired fan speed indicator lights up.
To control the direction of the air flow horizontally, please adjust the inner
louver by hand.
Note： The air conditioner stops if the room temperature is lower than
selected temperature.
B. Ventilating your room
Press MODE button repeatedly until the LED of FAN operation lights up.
In ventilation mode the room air is circulated, but not cooled.
Press SPEED button repeatedly to select the fan speed as desired.
C. Drying your room
Press MODE button on the control panel or remote control, the LED of DRY
operation lights up. The fan speed is unable to select. User should connect
the hose to the drain outlet at the bottom of the unit.
Note: In this mode, the fan speed switches over to low speed andthe
temperature cannot be selected.
D. Sleep mode （ this function can only be used with a
remote control）
The sleep mode can be activated when in cool mode and heat mode.

After 1 hour the preset temperature is increased by 1 ℃, after another hour the
preset temperature will again be increased by 1 ℃.
In cool mode :
20