Publicidad
Idiomas disponibles
Idiomas disponibles
Assembly Instructions
1
Installing the wall mounting bracket to wall
CAUTION: If you are going to attach the fan assembly (A) to
a wood stud or wood post, the stud or wood post must be
wide enough and thick enough to sustain the wall mounting
bracket (C) and the weight of the fan assembly (A).
WARNING: To reduce the risk of the fan falling, use all
four mounting holes in the wall mounting bracket (C)
when installing.
WARNING: It is very important that you use the proper
hardware when installing the wall mounting bracket (C)
as this will support the fan assembly (A).
□
Determine the approximate position of where you want the fan to
be located on the wall. Then, locate the stud in the wall. Position
the wall mounting bracket (C) on wood stud or wood post and
mark the location of the four holes using a pencil or a marker (not
included).
□
Use 3/32-in. drill bit (not included) to drill pilot holes at marked
locations. Then, install wall mounting bracket (C) to the wall using
the wood screws (GG) and washers (HH).
2
Attaching flanges to fan motor
□
Remove all the screws, spring washers and flat washers, then install the left flange (II) and right flange (JJ) accordingly.
A
II
Flat
washers
(4)
4
GG
HH
7 feet
minimum
JJ
Spring
washers
(4)
C
Screws
(4)
Publicidad
