Assembly Instructions (continued)
3
Installing the mounting pipe and
base assembly
□
Put one end of the pipe (B) into the slot in the base of the mounting
bracket (C).
□
Carefully insert the position knob and tighten it to hold the pipe (B).
4
Assembling the wall mount bracket
and motor assembly
CAUTION: Be sure to secure the knobs.
□
Remove the position bolt (CC), flat washer (DD), spring
washer (EE) and nut (FF) from the motor (A).
□
Align the holes on the pipe (B) with the holes in the motor
flange on the motor assembly.
□
Insert the position bolt (CC) through the top hole and replace
the flat washer (DD), spring washer (EE) and nut (FF) removed
in step 1.
□
Insert the pivot bolt (BB) through the bottom hole and secure
using the pivot knob (AA).
□
Adjust the tilt to the desired position and tighten the pivot
knob (AA) to set the angle.
□
Tighten the position bolt (CC) and nut (FF).
EE
DD
FF
BB
5
Please contact 1-855-HD-HAMPTON for further assistance.
B
C
A
CC
AA
B
HAMPTONBAY.COM