ROBBE Arrow Plus 222 Instrucciones De Uso página 5

Trimming the model, using stick mode 2 as an example
Fig. 34
1. Roll
2. Pitch-axis
3. Throttle trim
4. Yaw
Fig. 35:
Tip:
Landing
After the landing disconnect the flight battery from the receiver,
and only then switch the transmitter off.
Caution:
Take every care to avoid the rotor blades hitting any obstacles
when they are spinning, as stalling the blades can cause severe
damage to the mechanics and could even cause a fire. If the bla-
des are stopped, close the throttle immediately!
©
Arrow Plus 222, Arrow Plus Trainer
Note regarding the flight battery
Allow the battery to cool down again before recharging it.
Fig. 36: adjustment facilities on the receiver
Replacing the rotor blades
Replacement parts
Spare parts are only available in the sets as stated.
robbe Modellsport GmbH & Co. KG
Replacement parts for Arrow Plus 222 and Arrow Plus Trainer
Description
Note:
No. S2512
No. S2513
Order No.