Advanced Programming; External Sensor; Control Sensor - Orbis Thermo X Manual De Uso

ADVANCED PROGRAMMING

Advanced programming makes it possible to change some parameters and view some
system data.
The user-selectable parameters are:
PARAMETER READING
Temperature control
method
Control band
(ONLY when
rEG=P and
WINTER-HEATING
operating mode)
Control period
(ONLY when
rEG=P and
WINTER-HEATING
operating mode)
Differential
(ONLY when rEG=O)
Antifreeze temperature
(only when in
WINTER-HEATING
mode)
Unit of measurement

External sensor

Control sensor

ONLY when ESt=YES)
RS485 output enabled
(Out Bus)
DEFAULT PARAMETER RANGE
0 = ON/OFF
rEG 0
P = PROPORTIONAL
bnd 00.5 °C 00.5°C ÷ 05.0°C
PEr
10 minutes 10 – 20 – 30 minutes
dIF
00.3 °C 00.1°C ÷ 01.0 °C
01.0 °C ÷ 10.0 °C
0FF
06.0 °C
"---" = disabled
C=Celsius
deg
C
F= Fahrenheit
n0 = not provided
ESt n0
YES = external sensor
Int = internal
SnS Int
ESt = external
YES = enabled
bUS YES
n0 = disabled
- 86 -
User Manual - Thermo X
NOTES
The temperature is
kept pressing the
OFF key
External probe
X.TEMP
code VN883500
is connected
(optional)
Phone-control output