Orbis Thermo X Manual De Uso página 89

Memory address
(ONLY when bUS=YES)
Settings guard
password
Total number of hours
of output operation
Battery charge status
Display brightness
adjustment
To enter advanced programming and change the parameters
1) Hold down for 3 secs until the display reads "rEG"
2) Press or to select the desired value
3) Press to confi rm
4) Repeat steps from 2) to 3) to change the remaining Advanced Programmimg
parameters
5) After confi rming the parameter "(nt" the device resumes the previous operating
status (Automatic, Manual or System Off)
Description of advanced programming parameters
TEMPERATURE-CONTROL METHOD (rEG)
The choice of the temperature-control method depends on the features of the system
it is applied to.
In most cases ON/OFF temperature-control is recommended (which is
the default choice), but Proportional temperature control is preferable in
premises with a high thermal drift (large rooms, fan-coil systems, cast-iron
radiators, etc)
The Proportional method can only be selected for the WINTER-HEATING
mode.
Adr
PAS 123 000 ÷ 999
Tot 000 000 ÷ 65535 (7 years)
bAt 100% ÷ 0%
(nt 8 0 ÷ 15
- 87 -
User Manual - Thermo X
Upon initial start-up
procedure, default
parameters are
enforced an a new
address is generated
For use in public
premises
Total number of hours
when output relay in
ON status
The initial value
depends on the battery
charge