Descargar Imprimir esta página

Diamond TPS3B/L Manual De Instrucciones página 23

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 60
ENGLISH
5.
USE AND FUNCTIONING
5.1.
Description of the Controls
GB
1. Master switch (Switch-on is indicated by the
lighting-up of the incorporated green LED)
2. Remote-thermostat ON/OFF key
3. Setpoint setting key
4. Manual defrosting start key.
5. Digital remote-thermostat
5.2.
Functionality [
Switching the Remote-thermostat On and Off
Switching the instrument on (ON): press the
following key for a few seconds
is pressed the display shows ON).
Switching the instrument off (OFF): press this
key for three seconds
confirmed
by
temperature measured by the set probe shown on
the display.
Setting the Working Temperature
The temperature set during the factory inspection
is highlighted by pressing this button
This temperature remains on the display for 5
seconds during which it can be modified by acting
on
and
increase or decrease of the same.
After 5 seconds that the
not pressed, the temperature of the refrigerated
compartment is displayed again.
temperature of the compartment can be set by the
user between the maximum and minimum level,
highlighted in the top part of the door.
7
1
(when the key
. Switch-off is
"OFF"
alternating
with
.
, which respectively indicate the
and
keys are
The internal
2
3
5
6
4
6. Functioning status LED
7. High/low humidity switch (activation
enables the continuous ventilation
increasing humidity in the cell).
7.
Light switch on key (only models with
glass door)
2 3 4 Temperature modification keys
Defrosting
The
digital
controls defrosting of the evaporator. Defrosting is
indicated by the relevant LED.
During this phase it is recommended not to load
or unload the refrigerated compartment.
The end of defrosting is piloted by the relevant
probe.
the
In particularly hard working conditions (high
environmental temperatures and humidity or
following the introduction of substances with high
humidity transfer) it is recommended to perform
additional manual defrosting operations, by acting
for a few seconds on the
LED Display
There are graphic signals within the display area:
6
remote-thermostat
automatically
key.

Publicidad

loading