Publicidad
Idiomas disponibles
Idiomas disponibles
StarBoard Link EZ
Page
2.2 Installing the Devices (Using the Installation Wizard)
- For Windows users, run "Start" → "All Programs" → "StarBoard Link EZ Setup
Wizard".
2-2
2.3.6 Adjusting the Sensor
2.3.6.1 Sensor Adjustment Procedure
2-12～2-15
Windows contents
All Rights Reserved, Copyright © 2010,2014, Hitachi Solutions ,Ltd.
There is not "StarBoard Link EZ Setup Wizard".
2.3.6 Adjusting the Sensor
Items to Check Before Making Sensor Adjustments (Linux)
The following error may appear while using this product.
Check the following items if this error appears.
・There are no obstacles preventing the light from reaching the projection area, or
silver surface of the reflective bars.
・There is no dirt on the silver surface of the reflective bars.
If the problem is not corrected despite making the above checks, In the operating
system you are using, perform adjustment in accordance with " Sensor Adjustment
Procedure " shown in Section 2.3.6.1.
2.3.6.1 Sensor Adjustment Procedure (Linux)
[1] Press the "OK" button on the "LSaDrv Touch Sensor Error" dialog box displayed on
the Linux screen.
[2] Start the sensor adjustment wizard.
1 Debian
Select [Applications] → [Education] → [LsCamWiz].
[3] The sensor adjustment wizard starts. Click the "All adjust" button.
[4] Wait a while. If the "LsCamWiz ERROR" message does not appear, sensor
adjustment was successful. If an error such as the following appears, click the "OK"
button and then perform adjustment again while referring to Section 2.3.6. If
adjustment is still not successful, the StarBoard Link EZ2 unit may be defective.
[5] If adjustment was successful, click the "Exit" button.
* Note that just clicking the button does not complete the adjustment process.
[6] To save the adjustment result, click the "Yes" button.
This completes sensor adjustment.
After making adjustments, check that input can be performed normally.
6/33
Nov. 2014
Linux contents
English
Publicidad
