Publicidad
Idiomas disponibles
Idiomas disponibles
Page
3.2.1 Switching Input Methods (Windows)
3-4～3-5
3.3.3 Basic Operations of the Electronic Pen
3-8
3.3.4 Customizing the Electronic Pen
3.4.1 Start Method (Windows)
(5) Select "Start" → "All Programs" → "StarBoard Software," or double-click the
StarBoard icon on the desktop.
3-9～3-11
If the "No connection" icon in below appears on the Tasktray, it means that the
StarBoard Link EZ2 is not connected. Make sure that the StarBoard Link EZ2 and
the PC are properly connected.
Connected
(6) Run "LsCanWiz.exe" located under "My Computer" → "C Drive" → "Program
Files" →"Hitachi Software Engineering" → "FX-DUODriver", and adjust the sensor
according to the instructions on pages 2-10.
(*)This folder path may be changed since it depends on your Windows installation.
If the positions of the pen tip and cursor are out of alignment, select "MENU" on the
StarBoard Software toolbar → "Settings" → "StarBoard"→ "Calibrate," and then
perform position alignment.
Windows contents
No Connection
All Rights Reserved, Copyright © 2010,2014, Hitachi Solutions ,Ltd.
Same as Windows.
Same as Windows.
Same as Windows.
3.4.1 Start Method (Linux)
(5) Start the StarBoard Software.
[1] Debian
Select [Applications] → [Education] → [StarBoard].
If the "No connection" icon in below appears on the Tasktray, it means that the
StarBoard Link EZ2 is not connected. Make sure that the StarBoard Link EZ2 and the
PC are properly connected.
Connected
(6) Start the LsCamWiz.
[1] Debian
Select [Applications] → [Education] → [LsCamWiz].
Adjust the sensor according to the instructions on 2.3.5.1.
If the positions of the pen tip and cursor are out of alignment, select "MENU" on the
StarBoard Software toolbar → "Settings" → "StarBoard"→ "Calibrate," and then
perform position alignment.
9/33
Nov. 2014
Linux contents
No Connection
English
Publicidad
