Clock Time; Displaying The Clock Time; Setting The Clock Time (Timeset) - Bosch DAF Radio Basic Instrucciones De Manejo E Instalación

Sound | Clock time
Resetting the sound settings
You can reset all the sound settings to their
respective factory settings.
u Press the AUD button ⑦ to open the
menu.
u Press the AUD button ⑦ repeatedly until
"RESET N" appears in the display ④.
u Turn the volume control ① clockwise to
select the "RESET Y" setting.
All the sound settings will be reset after
approximately 2 seconds.
To close the menu,
u press the AUD button ⑦ (if necessary,
several times).
Notes:
You can reset the sound settings at
any time by holding down the AUD
button ⑦ for longer than 2 seconds.
In this case, the treble and bass
settings will only be reset for the
currently active audio source.
Robert Bosch Car Multimedia GmbH

Clock time

Displaying the clock time

To show the clock time in the display ④ for
approximately 10 seconds,
u hold down the MENU button ⑤ for longer
than 2 seconds.
Note:
Depending on the clock mode
selected, the following information
will be displayed in front of the time:
"24H" is shown in 24-hour mode, and
"AM" (before noon) or "PM" (after
noon) is shown in 12-hour mode.
To set the clock mode, please read
the section entitled "Selecting
12/24-hour clock mode (MODE)" in
this chapter.

Setting the clock time (TIMESET)

u Press the MENU button ⑤ to open the
menu.
u Press the MENU button ⑤ repeatedly
until "TIMESET" and the current setting
appear in the display ④.
The current clock time appears in the display
④ after approximately 2 seconds. "24H" is
displayed in front of the clock time in 24-hour
mode, and "AM" (before noon) or "PM" (after
noon) is displayed in 12-hour mode. The hours
flash and can be adjusted.
To adjust the hours/minutes,
u turn the volume control ① anticlockwise
or clockwise.
To switch between hours and minutes,
u press the 6 button ⑧.
7 620 000 111/ 7 620 002 112 | 12.2019
en | 35