Using The Foot Valve - GENERGY CIDACOS II Instrucciones De Uso

Types of GENERGY CAMLOCK connectors available
TYPE A TYPE B
MALE CAMLOCK FEMALE CAMLOCK
FEMALE THREAD MALE THREAD
References of available CAMLOCK connectors by diameter and type
Diameter TYPE A
1"
2015201
1-1/4"
2015202
1.1/2"
2015203
2"
2015204
3"
2015205
4"
2015206
In bold 1-1/2" the right size for this model.
4.5 Using foot valve (not included).
The time required to complete the aspiration and the pump starts expelling water
depends on the depth at which it aspires. If it aspires water at the pump level, the
pump will pump water immediately. But if we are at 4 or 5m aspiration time will be
much longer reaching 2 minutes or more depending on the model. Remember that
the pump body must be filled with water at all times!
When aspirated into deep (a meter or more) we recommend the use of a foot valve.
This remains installed at the tip of the aspiration hose replacing the aspiration filter.
The foot valve only allows circulating water in an upward direction, not allowing the
water back.
Advantages:
 After using the motor pump its body and the hose will remain filled with water
because the foot valve will not allow the water back.
TYPE C TYPE D
FEMALE CAMLOCK FEMALE CAMLOCK
HOSE FEMALE THREAD
TYPE B TYPE C
2015211 2015221
2015212 2015222
2015213 2015223
2015214 2015224
2015215 2015225
2015216 2015226
35
TYPE E
MALE CAMLOCK
HOSE
TYPE D TYPE E
2015231 2015241
2015232 2015242
2015233 2015243
2015234 2015244
2015235 2015245
2015236 2015246
TYPE F
MALE CAMLOCK
MALE THREAD
TYPE F
2015251
2015252
2015253
2015254
2015255
2015256