SICK Smart Light Tower SLT060-0B010J700 Instrucciones De Operación página 35

7.2 Notes on UL approval
7.2.1 UL Satisfaction Ratings
8 Operation
8.1 Operating modes
8.1.1 Signal lamp mode
8.1.2 Filling level mode
8026183.1FJ5/2022-11-17 | SICK
Subject to change without notice
The Smart Light Tower is a UL Recognized Component (file no. E198242).
Standard for safety:
• UL 508, Standard for Industrial Control Equipment
• CSA C22.2 No. 14-18, Standard for Industrial Control Equipment
The following compliance requirements of UL certification must be considered:
• A class 2 voltage supply unit must be used for the voltage supply
There are 3 different operating modes for the SLT, which are used to display various
warning and indicator signals:
•
Signal lamp mode
• Filling level mode
• Animation mode
In Signal lamp mode, the SLT can be used as a standard signal lamp.
The 20 LED segments can be divided into a maximum of five groups. When evenly
distributed, four LEDs together always form a group. The number of LEDs per group
can be changed individually. Even if only one group is activated, all 20 LEDs are always
used for visualization. Exception: If the group separation function is activated, one row
of LEDs is switched off between the individual segments and the remaining number of
LEDs is reduced to 15.
The colors of the different groups can be selected from a color palette with eight
predefined colors. In addition, another individual color from a total of 21 predefined
colors can be added to the color palette here.
In Signal lamp mode, the LEDs can be set as either continuous light, flashing light,
strobe light, or pulsating light. The light animation frequency can be set individually.
Filling level mode is used when the SLT is used as a level indicator or filling level display.
For this purpose, a level value is specified in the process data. The higher the level
value (in percent), the more LEDs are switched on at the signal lamp.
Each of the 20 LED segments can be individually colored from 21 predefined colors.
As in Signal lamp mode, each individual segment can be configured with a different
light pattern. Continuous light, flashing light, strobe light or pulsating light is available
for selection. The light animation frequency can be set individually.
OPERATING INSTRUCTIONS
O P E R A T I N G I N S T R U C T I O N S | SLT
en
35