SICK Smart Light Tower SLT060-0B010J700 Instrucciones De Operación página 39

8.2.1.2.1
8026183.1FJ5/2022-11-17 | SICK
Subject to change without notice
Update page
Restore factory settings
Edit
Operating mode
STATUS page
The "STATUS" page is the start page for the SLT. On this page, you can set the process
data that is cyclically transmitted to the SLT. The process data available for writing
differs depending on the operating mode set.
NOTICE
For writing process data on the status side, at least SOPAS ET version V2021.2 is
required. Alternatively, an IO-Link master can be used to write the process data.
After clicking on this button, the page contents are updated.
When you click on this button, all settings of the SLT are reset to
their factory values.
Click the Edit button to change the settings on the current parame‐
terization page. When the Edit button is pressed, it is highlighted in
light blue. Configurable pages are displayed in gray until Edit mode
is activated.
With the SLT, there is only the RUN operating mode. No password
is provided for this operating mode. With other SICK products,
there are other operating modes that require entry of a password.
O P E R A T I N G I N S T R U C T I O N S | SLT
OPERATING INSTRUCTIONS
en
39