Reverse Door - Domo DO937DV Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 40

Reverse Door

oor
5.
Take the hinge pin out of the hinge bracket. Turn the bracket around and tighten the pin again.
5. Unscrew and remove the bottom hinge pin, turn the bracket over and replace it.
move the bottom hinge pin, turn the bracket over and replace it.
oor
oor
move the bottom hinge pin, turn the bracket over and replace it.
move the bottom hinge pin, turn the bracket over and replace it.
Unscrew
Unscrew
Unscrew
6. Refit the bracket fitting the bottom hinge pin. Replace both adjustable
6.
Attach the screws, hinge bracket and adjustable foot to the opposite side of the bottom. Loosely
feet.
secure.
fitting the bottom hinge pin. Replace both adjustable
fitting the bottom hinge pin. Replace both adjustable
fitting the bottom hinge pin. Replace both adjustable
7. Place the door back on. Ensure the door is aligned horizontally and
7.
Carefully set the door back into place. Ensure the door is aligned horizontally and vertically so that
vertically, so that the seals are closed on all sides before finally
tightening the top hinge.
the seals are closed on all sides before finally tightening the top hinge. Insert the hinge back and
ack on. Ensure the door is aligned horizontally and
t the seals are closed on all sides before finally
screw it to the top of the appliance.
p hinge.
ack on. Ensure the door is aligned horizontally and
t the seals are closed on all sides before finally
p hinge.
ack on. Ensure the door is aligned horizontally and
t the seals are closed on all sides before finally
p hinge.
8. Put the top cover and fix it with 2 screws on the back.
r and fix it with 2 screws on the back.
8.
Put the top cover back and fix it in place with the screws.
r and fix it with 2 screws on the back.
r and fix it with 2 screws on the back.
9. Fix the thermostat knob.
at knob.
at knob.
MOVING YOUR APPLIANCE
at knob.
·
If the appliance is turned off for any reason, wait for 10 minutes before turning it back on. This will
allow the refrigeration system pressures to equalise before restarting.
·
Turn off the appliance and unplug it from the mains socket. Remove all food. Also remove all mobile
parts (shelves, accessories, etc.) or fix them into the freezer to avoid any shock.
·
Relocate and install. If the appliance has been left on its side for any length of time, leave it standing
upright for at least 10 minutes.
www.domo-elektro.be
Unscrew
8
8
8
Screw
Screw
Screw
screw
screw
screw
8
Screw
screw
DO937DV
35

Publicidad

Tabla de contenido
loading

Tabla de contenido