Sound Controls; Equalizer; P.bass Control; Bass/Treble Control - Pioneer X-CM56 Manual De Instrucciones

04 Getting started

Sound controls

Equalizer

When the EQ is pressed, the current mode setting will be
displayed. To change to a different mode, press the EQ
repeatedly until the desired sound mode appears.
FLAT
ACTIVE
DIALOGUE
NIGHT

P.BASS control

When the power is first turned on, the unit will enter the
P.bass mode which emphasises the bass frequencies. To
cancel the P.bass mode, press the P.BASS on the remote
control.

BASS/TREBLE control

Press the SOUND to select "BASS" or "TREBLE", then
press  /
to adjust the bass or treble.
Note
• The EQ and P.BASS cannot operate simultaneously.
The most recently selected of these two functions will
be the one used.
• SOUND can operate alongside either the EQ or
P.BASS.
When one of the above two functions is selected,
the function that is not selected will be displayed
as follows.
1 When P.BASS setting (ON/OFF) is changed
• EQ : FLAT
2 When EQ setting is changed
• P.BASS : OFF
14
En
A flat and basic sound
A powerful sound that
emphasizes low and high tones
A sound that allows the radio or
vocals to be heard more easily
A sound that can be enjoyed
at night even with lower volume

Setting the wake-up timer

Used to change the existing timer setting, or to set a new
timer.
1 Press Í to turn the power on.
2 Press and hold TIMER on the remote
control.
Press  /
3 to select "ONCE" or "DAILY",
then press ENTER.
ONCE – Once timer play works for one time only at a
preset time.
DAILY – Daily timer play works at the same preset time
and days of week.
4 Press  / to select "TIMER SET", then
press ENTER.
Press  /
5 to select the timer playback
source, then press ENTER.
CD, DAB (X-CM56D only), FM, AM (X-CM56 only), and USB
can be selected as the playback source.
Press  /
6 to select the timer day, then
press ENTER.
Press  /
7 to set the hour, then press
ENTER.
8 Press  / to set the minute, then press
ENTER.
Set the time to finish as in steps 7 and 8 above.
9 Adjust the volume press VOL +/– , then
press ENTER.
" " appears on the display.
10 Press Í to enter the power standby mode.
The TIMER indicator lights up.