SunPower SPR X Serie Instrucciones De Seguridad E Instalación página 15

SunPower Performance 6 COM-S BIFACIAL Solar Panel
(SPR-P6-XXX-COM-S-BF)
50
TOP CLAMPS
Moun ng Moun ng Configura on Diagram
Configura on
Descrip on Front View Back View
Long Side Moun ng,
Rails Perpedincular to
Moun ng Frame
Long Side Moun ng,
Point Supported
Long Side Moun ng,
Rails Parallel to
Moun ng Frame
Short Side Moun ng,
Point Supported
(End Mount)
Short Side Moun ng,
Rails Parallel to
Moun ng Frame
(End Mount)
Design Load considers 1.5 Factor of Safety, Test load = Design load x 1.5. Product Warranty covers only design
load values. The design loads listed in this table supersede all other loads that may be defined by other
par es, unless there is a formal authoriza on by Maxeon.
2 Test loads are for informa on purposes only, design loads should be considered for the project design.
3 In the cases where hybrid moun ng is necessary (combina on of long and short side moun ng), the lowest
design load values should be considered as allowable design load.
©June 2023 Maxeon Solar Technologies, Ltd. All rights reserved. Specifications included in this manual are subject to change without notice.
496 596 942
1100 mm
1400 mm
2185 mm
A - Ground Holes (4X Ø 4.2mm)
B - Moun ng Holes (8X 9mm (W) x 14mm (L), R4.5mm)
Measurement Tolerances are +/-3mm for the Length and Width of the module.
Moun ng Zone
Test Load Design Load
Loca ons
Downward/Upward Downward/Upward
(distance from corner
(Pa) (Pa)
in mm)
+1800/-1600 +1200/-1066
50 - 496
496 - 596 +5400/-2400 +3600/-1600
+2400/-1600 +1600/-1066
596 - 942
50 - 496 +1800/-1600 +1200/-1066
+2000/-1600
496 - 596 +3000/-2400
+1600/-1066
596 - 942
+2000/-1600
50 - 496 +2800/-1800 +1867/-1200
+1867/-1200
496 - 596 +2800/-1800
+1867/-1200
596 - 942 +2800/-1800
+800/-666
0 - 100 +1200/-1000
+1600/-1600 +1066/-1066
100 - 323
+1600/-933
223 - 323 +2400/-1400
Safety and Installation Instructions - Document 001-15497 Rev.AA
496
942 596
B
GEN 4.3 FRAME PROFILE
SIDE FRAME PROFILE
35 mm
30 mm
BOLTS
Moun ng Moun ng Configura on Diagram
Configura on
Descrip on Front View Back View
Long Side Moun ng,
Rails Perpendincular
to Moun ng Frame
4 Bo om flange moun ng
5 Range indicates posi oning of the clamp and not the rails.
MAXEON SOLAR TECHNOLOGIES, LTD.
50
A
END FRAME PROFILE
35 mm
16 mm
Moun ng Zone
Test Load Design Load
Loca ons
Downward/Upward Downward/Upward
(distance from corner
(Pa) (Pa)
in mm)
1100mm Holes +5400/-2400 +3600/-1600
1400mm Holes +5400/-2400 +3600/-1600