Descargar Imprimir esta página

FALMEC Design Elios Angolo 100 Inox Manual De Instrucciones página 22

Publicidad

SPEED - Switch B
This is used to start and set the speed of the motor, from 1 to 3, or with continuous speed
variator, depending on the version.
LIGHT - C
Motor operation indicator light.
2. FIVE BUTTON CONTROL PANEL
LIGHT- button
Pressed: the light is on
Released: the light is off
MOTOR button - 1, 2, 3, OFF
1: starts the motor at minimum speed
2: starts the motor at medium speed
3: starts the motor at maximum speed
OFF: stops the motor
H
FILTERS
1. METAL FILTERS
To remove the metal grease-trapping filter, simply pull the handle A until releasing it from
the front guide; then tilt it slightly downwards, and slide it out of the rear guide. To reposi-
tion the filter, repeat the operation in the reverse order.
2. CHARCOAL FILTERS
To replace the charcoal filters, proceed as follows: remove the metal filters as described
above. The two filters located at the ends of the motor can now be easily accessed.
To install the new fi lters see picture.
In case of hood with the motor box the fi lter is located on the botton part of the motor box.
To install the new fi lters see picture.
To order new charcoal fi lters contact the distributor/retailer.
VALID ONLY FOR ITALY: download the appropriate order form from: www.falmec.com (access
the assistance drop-down menu).
16
REMOVING AND REPLACING'S INSTRUCTIONS
A

Publicidad

loading