Publicidad
Idiomas disponibles
Idiomas disponibles
MACHINE PLACEMENT
Place the Automatic Stretch Wrap Machine close to
an area where you will be wrapping your pallet loads.
Make sure that there is sufficient room to load/unload
the machine and that you do not stretch the wiring
cable. Remember, you will need to provide electrical
service to a 120 VAC, 15-AMP outlet.
FLOOR WEIGHT BEARING TOLERANCE
The floor must be able to bear the weight of the
machine, the weight of the maximum load, plus a
safety factor. The floor must also be able to tolerate
the stress of the machine's operation. If fork trucks
will operate on the same weight bearing area, add
the weight of the trucks to the weight bearing stress
tolerance requirements.
PAGE 3 OF 33
SYSTEM SET-UP
MACHINE SET-UP
1. Place skidded machine close to the designated
wrap area. Remove all shipping fasteners holding
the machine to the pallet. The machine may be
crated with the tower tilted down with the motor
cover front carriage roller removed for shipping
purpose.
2. Place forks of the forklift through the tubes provided
at the rear base of the module, remove the
machine from these skids, and place it at the
designated wrap area.
3. If the OPTIONAL ramp (H-1071) is purchased:
Select a ramp position as illustrated below. The
ramp can be positioned anywhere in a 180°
rotation around the front of the turntable. There
should be a 1/4" gap between the turntable and
the ramp. The ramp should be fully supported by
the floor. (See Figure 1)
180°
Figure 1
1/4" Gap
1023 IH-3701
Publicidad
