RIB AC07088 Manual De Instrucciones página 24

G
B
A - CONTROL PANEL FEATURES
J1 N F Power supply 230 Vac 60/50 Hz - external to the control
panel - (120V/60Hz upon request)
J2 COM. Common contact
CLOSE Closing impulse contact (NA)
OPEN Opening impulse contact (NA)
STOP STOP impulse contact (NC)
AERIAL Radio Antenna
SIGNAL Gate open state and battery state output indicator (24Vdc 3W
max)
J3 A+TEST + 24Vdc safety strip self-test power supply
EDGE N.C. Safety strip contact (NC)
COM. Common contact
PHOTO N.C. Photocells contact (NC)
K BUTT. Single pulse contact (NO)
PED. BUTT. Pedestrian opening contact (NA)
A+ + 24Vdc accessories power supply
A - - 24Vdc accessories power supply
LOCK Electric lock connection (MAX 15W 12V)
- 24Vdc blinker (code ACG7061) power supply. Pay attention
to the polarity.
J4 SECONDARY Connection to secondary coil of transformer 18 Vac
TRANSFORMER
J5 MOTOR 1 MOTOR 1 CONNECTION (without polarity)
J6 MOTOR 2 MOTOR 2 CONNECTION (without polarity)
J7 Connector dedicated to the factory programming. DO NOT
REMOVE ANY JUMPER! OTHERWISE THE OPERATOR WILL
NOT WORK!
SW T24 2V
J8 Connector dedicated to the factory programming (only CRX
control board) DO NOT REMOVE ANY JUMPER! OTHERWISE
THE OPERATOR WILL NOT WORK!
SW RADIO
J9 RADIO Built-in radio module (model CRX), or connector for radio
receiver RIB, 24 Vdc supply
J10 BATTERY Connector for charge card of 24Vdc battery (code ACG4648)
CHARGER
TR1 TRIMMER RUN Trimmer for high speed adjustment operations
TR2 TRIMMER LOW Trimmer for low speed adjustment operations
SPEED
TR3 TRIMMER TCA Trimmer for automatic closing time adjustment (DISABLED
DEFAULT AND DL6 LED OFF)
S3 PROG Programming button
FUSE 1 T 8 A Motor protection fuse
F1 T 2 A Transformer protection fuse
J2
J9
J10
J8
J7
S3
24
J1
F1
J3 TRANSFORMER
J4
FUSE
1
BRIDGE
J5
J6
TR3
TR1 TR2