Publicidad
Idiomas disponibles
Idiomas disponibles
English – 10
Connection of the on-board computer to
the eBike (pairing)
Your on-board computer is generally already con-
nected with the eBike. If this is not the case, proceed
as follows:
– Install the eBike Flow app.
– Activate Bluetooth® on your smartphone and open
the eBike Flow app.
– Briefly press the Bluetooth® button.
– The device identification is shown on the on-board
computer.
– Select the required tool with the same identifica-
tion in the eBike Flow app.
You can find further information at the following link:
www.bosch-ebike.com/de/help-center/intuvia-100.
Depending on the operating system of the
smartphone, the eBike Flow app can be
downloaded free of charge from the Apple
App Store or Google Play Store.
Scan the code with your smartphone to download the
eBike Flow app.
Switching the On-board computer On/Off
Switch on the eBike.
To switch on the on-board computer, it must first be
inserted in the holder. The on-board computer con-
tact (4) is automatically pressed.
Switch on the operating unit and slowly move the
eBike.
The following options are available for switching off
the on-board computer:
– Press the on/off button on the operating unit to
switch off the eBike.
The on-board computer is also switched off.
– Remove the on-board computer from its holder.
The on-board computer switches off automatically
after 60 s.
Power supply of the On-board Computer
The on-board computer is provided with energy by
the CR2450 button/coin cell.
0 275 U07 3BI | (03.03.2023)
Operation
Changing the coin cell
(12)
If the coin cell of the on-board computer is almost
empty, you will be shown a corresponding message
on the on-board computer. Open the battery com-
partment cover (2) with a slotted screwdriver (12),
remove the used coin cell and insert a new coin cell of
type CR2450. You can obtain the coin cells recom-
mended by Bosch from your bicycle retailer.
When inserting the coin cell, ensure that the coin cell
is inserted with the label facing upward and that the
rubber seal (14) is positioned correctly.
Seal the battery compartment and slide the on-board
computer onto the holder.
Battery charge indicator of the eBike
battery
The on-board computer shows the state of charge of
the eBike battery in percent. A notification is dis-
played once when the state of charge falls below
30 %, and again when it falls below 10 %. The notifi-
cation can be acknowledged, otherwise it goes away
automatically after 5 s.
Operation
The Bluetooth® button (1) has various functions. If
the on-board computer was connected with an oper-
ating unit and has been removed from the holder, the
displays can be switched within 60 s. To do so, briefly
(2)
(13)
(14)
Bosch eBike Systems
Publicidad
