Makita DCL181F Manual De Instrucciones página 9

Disposing of dust for high
performance filter
1. In order to drop dust sticking on the filter in the capsule,
tap the capsule 4 or 5 times with your hand.
Now point suction inlet downwards, turn capsule in direction of
arrow in diagram, and disconnect capsule slowly and straight.
Fig.13
► 1 . Capsule 2. Suction inlet
NOTE: Dust may spill out when capsule is opened, so
be sure to set a garbage bag beneath capsule.
2. Remove accumulated dust from inside of capsule
and off of high performance filter.
Fig.14
► 1 . Capsule 2. High performance filter
3. Twist high performance filter in direction of arrow
to unfasten securing lip from cleaner unit and then pull
off the filter.
Fig.15
► 1 . Securing lip
4. Clean out the fine dust and lightly tap to dislodge
dust from high performance filter.
1
2
1
2
1
Reassembly
Reassembly for normal filter
1. Put on filter until it is fully in position on the cleaner
unit.
1
Fig.16
► 1 . Filter
Fig.17
► 1 . Filter
NOTE: Make sure filter is put on straight without
being peeled back. If filter is put on incorrectly as
shown in diagram, dust will get into motor housing,
and cause motor failure.
2. Connect prefilter. At this time, make sure to twist
prefilter so that securing lip is firmly locked into cleaner
unit.
Fig.18
► 1 . Prefilter
9 ENGLISH
1
1