Publicidad
Idiomas disponibles
Idiomas disponibles
• Place the 2 caps in the 2 holes at the top of the cabinet, ensuring that you do not
push them all the way in.
• Slide the rear stop between the caps and the wall of the cabinet, then push the 2
caps all the way in.
• If the appliance is not able to reduce humidity
levels to the desire value, remove the black
discharge pipe located at the base of the
cabinet.
• Place your cabinet in the desired location.
Recommendation
If you leave your wine cabinet closed for long periods (>3 months) in an environment where the
temperature is close to your cabinet's temperature setting (a difference of about <5°C) this could
create an environment in which mould develops or cause your bottles's labels to peel off. Lack of
dehumidification and air renewal can create significant humidity inside the cabinet. We strongly
recommend that you regularly monitor your cabinet and clean it once a year.
The location that you choose for your cabinet must:
- be open to the outside and well ventilated (not in an enclosed cupboard, for example),
- allow there to be a minimum space of 7 cm between the wall and the back of the cabinet,
- not be close to any source of heat,
- not be too damp. Max 85% ambient humidity (linen cupboard, laundry room, bathroom...).
- have a flat, stable floor,
- be supplied with standard accessible power (outlet that complies with standards in force in your country,
earthed with circuit breaker).
It is forbidden to use an extension cord or adaptor.
Installation of two cabinets side by side
Caution: In the case of two side by side cabinets installed in extreme conditions (Temperature >30°C -
Relative Humidity > 70%), in order to prevent condensation of stagnant air between the walls, please leave
either a minimum space of 5 cm between the two cabinets, or fill the space with a foam sheet to remove
the void.
Fitting the handle
In order to correctly fit the handle on your wine cabinet's solid door, please
follow these instructions.
Prepare the items required for assembly, supplied with your cabinet:
- The handle
1
,
- 2 handle tubular supports
- 2 washers
3
,
- 2 screws
,
4
- 2 caps
5
.
You will also need a flathead screwdriver (not supplied)
Instructions :
1. Insert 1 washer on 1 screw.
2. Insert the handle tubular support then the screw in the hole provided on the inside of the wine cabinet
door.
3. Use the screwdriver to screw the screw into the handle post and gently tighten.
4. Place the cap on the screw head.
5. Repeat this procedure for the other handle post.
Recommendation
To allow you to easily level your wine cabinet, it is fitted with 2 adjustable feet at the front.
Carry out final levelling of your cabinet (spirit level recommended).
WAIT 48 HOURS BEFORE PLUGGING IN YOUR APPLIANCE
When moving your cabinet, never tilt it more than 45°, and always on its side (on the opposite side of
the flexible lead).
,
2
1 5
4
3
2
1
GB
7
Publicidad
