Publicidad
Idiomas disponibles
Idiomas disponibles
Set-Up
Chute Control Cable Routing (If
Equipped)
For units equipped with 2-way or 4-way chute
control joystick, electric chute control and/or
chute-pitch controls, ensure control cables are
routed properly.
Chute control cables are routed through a
single wire guide (a) on top of the engine and/
or through two wire guides (b) located on the
left side of the unit.
NOTE: For smoothest operation, cables should
all be to the left of the chute directional control
rod.
NOTE: The number of cables routed through
the wire guides will depend on unit model.
1.
Locate cable guide(s) and perform the
following:
•
Units with Top Mounted Wire Guide (a) -
Check that all cables are properly routed
through cable guide on top of engine.
See Figure 2-35.
•
Units with Side Mounted Wire Guides
(b) - Check that all cables are properly
routed through the wire guide below
the left side of the engine and the wire
guide below the chute control head.
See Figure 2-35.
(c)
(c)
Figure 2-35
Shear Pins Storage (If Equipped)
On select units, holes are provided in the rear
of the handle panel for shear pin (a) and
bow-tie cotter pin (b) storage as shown in
Figure 2-36. If not provided, make sure to store
them in a safe place until needed.
(a)
(b)
(a)
(b)
Chute Clean-Out Tool
The chute clean-out tool is fastened to the top
of the auger housing with a mounting clip. See
(a)
Figure 2-37.
(b)
(a)
(b)
Figure 2-36
Figure 2-37
Adjustments
Chute Assembly
NOTE: For models with 2-Way/4-Way or Electric
Chute Directional Control and/or models
with chute-pitch controls see Controls and
Operation on page 15.
On units with manual chute tilt the distance
snow is thrown can be adjusted by changing
angle of chute assembly. To do so:
1.
Loosen wing knob found on left side of
chute assembly. See Figure 2-38.
Figure 2-38
2.
Pivot chute upward or downward before
retightening wing knob.
Drift Cutters (If Equipped)
The drift cutters are mounted inverted at the
factory for shipping purposes.
1.
Loosen the two carriage bolts (a) and
wing nuts (b) that secure each drift
cutter to the sides of auger housing. See
Figure 2-39.
(a)
(a)
Figure 2-39
2.
Slide the drift cutters to desired height.
3.
Securely tighten the two carriage bolts
and wing nuts that secure each drift
cutter to the sides of auger housing.
S
2 — A
& S
ection
SSembly
et
(b)
(b)
-U
11
p
Publicidad
