MTD 769-22275 Manual Del Operador página 7

Overhead Chute Control (w/
Chute Control Rod)
Chute
Assembly
Overhead Chute
Control Rod
Figure 2-6
1. Remove wing nut (a) and hex
screw (b) from chute control head and
clevis pin (c) and cotter pin (d) from
chute support bracket. Position chute
assembly (forward-facing) over chute
base. See Figure 2-7.
Chute Control Head
(b)
(c)
(d)
(a)
Chute
Chute Base
Figure 2-7
2. Place chute assembly onto chute base
and secure chute control head to chute
support bracket with clevis pin (c) and
cotter pin (d) removed in Step 1.
See Figure Figure 2-8.
3. Finish securing chute control head to
chute support bracket with wing
nut (a) and hex screw (b) removed in
Step 1. See Figure 2-9.
4. Insert chute control rod into the support
bracket on rear of the dash panel. See
Figure 2-10.
Chute
Support
Bracket
(c)
(d)
Figure 2-8
(b)
(a)
Figure 2-9
Figure 2-10
5. Remove hairpin clip (a) from rear of
chute control head. See Figure 2-11.
(a)
Figure 2-11
6. Insert chute control rod (b) into rear
of chute control head. See Figure 2-11.
Secure chute control rod to chute
control assembly with hairpin clip (a)
removed in Step 5.
STOP
Continue to Set-Up (page 11).
S 2 — A & S
ection SSembly
(b)
-U 7
et p