Correct Purpose Of Use; Safety Symbols - hafele DT 100 Instrucciones De Montaje

2.2 Correct purpose
of use

2.3 Safety symbols

The DT 100/DT 100 FH is intended exclusively for use in an access control system.
Correct purpose of use also includes observing all specifications contained in these
instructions.
Any use beyond or other than the correct purpose of use shall be deemed improper
use.
The following stickers are located on one or more components of the access control
system. They relate to the immediate environment of where they are located.
Electric voltage
Only qualified electricians are permitted to work on such marked
components.
Unauthorised persons may not open the such marked cabinet.
Crossed-out dustbin
This image indicates that the respective component must not be
disposed of with residential waste.
Do not touch
Components with this marking could be damaged by touching.
Lead
The circuit board does not contain lead.
17