HAPIMP SV-TCQ Guia Del Usuario página 16

Preparing the Camera
installed at the proposed drilling location!
■ The supplied wall plugs are only suitable for mounting on concrete
or stone. Before starting the installation, please check your installation
location carefully for its suitability for the plugs. The assembly
material used must be suitable for the respective location. If in doubt,
consult a professional.
Steps
♦Mark the drill holes by holding the foot of the wall bracket at the
desired mounting location and marking the hole positions.
♦Use a drill with a 6 mm drill bit to drill the required holes and insert
the plugs and insert the wall plugs flush with the wall.
♦Screw the wall bracket to the wall using the supplied screws.
♦Mount the camera on the tripod screw and screw the camera a little
way on (about three turns).
♦Turn the camera in the desired direction and lock it with the lock nut.
♦To move the camera into its final position, undo the two pivot bolts a
little, position the camera, and fix the position by tightening the two
pivot bolts through the hexagonal screw.
12