HAPIMP SV-TCQ Guia Del Usuario página 21

Basic Operation
3.1.2. When the camera is under the "ON" mode
After you have finished all the setting under the TEST mode and have
had the general location determined, you can switch the camera to ON
and it to work. The screen will display 5 seconds countdown and the
right LED indicator will light up. Then the LEDs and screen will be off.
The camera begins to operate independently and enter standby mode.
If wild animals enter the detection range of the motion sensors, the
camera will be activated and detect the motion.
If wild animals keep on moving in the detection zone of the sensor, the
camera will take photos or record video automatically.
When wild animals leave the detection zone of the sensors, the camera
will be deactivated and turn back in standby mode.
3.1.3. When the camera is under the "OFF" mode
The camera is completely turned off.
Notice about the 2 LED indicators under the TEST and ON modes:
1. Under TEST mode: when switching to TEST mode, the camera will
check IR LEDs for 3 seconds, and the IR LEDs will light up and 2
LED indicators on the left and right will flash.
2. After the camera is under TEST mode for one minute, if you shake
your hands in front of the camera sensor, the motion sensor will be
triggered and the left LED indicator will flash, which means the motion
sensor is working properly. (This can be used to detect if the camera's
sensor is working properly.)
3. Under ON mode: When the camera is switched to ON mode, the
17