Pioneer SUPER TUNER III DEH-P8250 Manual De Operación página 33

Idiomas disponibles

Subwoofer Setting Adjustment (Sub-W2)

When the Subwoofer output is ON, you can adjust the cut-off frequency and the output

level of Subwoofer.

1. Press the AUDIO button and select the Subwoofer setting mode

(Sub-W2) in the Audio Menu.

2. Select the frequency to 50 Hz,

80 Hz or 125 Hz with the 2/3

buttons.

3. Increase or decrease the output

level with the 5/∞ buttons.

The display shows "+ 6" – "– 6".

Note:

• You can select the Subwoofer setting mode only when Subwoofer output is switched ON in the

Subwoofer ON/OFF mode.

Non Fading Output (NonFad)

When the Non Fading Output setting is ON, the audio signal does not pass through this

unit's low pass filter (for the Subwoofer), but is output through the RCA output.

Note:

• When the Subwoofer Controller setting is only "S.W Control:EXT", you can switch the Non

Fading Output ON/OFF mode. (Refer to page 40.)

1. Press the AUDIO button and select the Non Fading Output ON/OFF

mode (NonFad) in the Audio Menu.

2. Switch the Non Fading output

ON/OFF with the 5/∞ buttons.