JUMO hydroTRANS S20 Manual Breve página 46

10 Shutdown
10 Shutdown
10.1 Dismounting
Aids
Requirements:
• The system has been de-energized and secured against being switched on again.
Procedure:
1. Loosen the union nut on the connecting cable.
2. Remove the connecting cable.
3. Undo the fastening screws.
4. Dismount the device.
10.2 Returns
Procedure:
1. The supplementary sheet for product returns
close it with the shipping documents and attach it to the packaging, ideally on the outside.
2. Use the original packaging or a suitably secure container for sending the device.
10.3 Disposal
• Do not dispose of the device or replaced parts in the trash after use.
• Delete programs and data stored on the device.
• Remove batteries, if any, if this can be done without damaging the device.
• Dispose of the device and the packaging material in a responsible and environmentally friendly man-
ner.
• Observe the country-specific laws and regulations for waste treatment and disposal.
In accordance with Directive 2012/19/EU on Waste from Electrical and Electronic Equipment, manufac-
turers are obliged to offer the option of returning waste equipment. Request the return from the manu-
facturer.
20
Screwdriver
must first be completed correctly and signed. Then en-