General
2
General
2.1
Authorized use
•
The device is only designed for the use specified in this documentation.
•
Every other use is not authorized and is forbidden!
•
All relevant safety regulations, corresponding legal regulations, especially regulations of the
declaration of conformity, and additional local health and safety regulations must be observed.
Prior to every operation the user must ensure that:
•
The equipment is suited to the intended operation
•
the functioning and the working condition of the equipment is examined
•
the load is suitable to be handled.
Any doubts about instructions should be raised with the manufacturer prior to use.
The device TAS-UNI is universally suitable for precise and flexible screeding of laying courses on both, large and
small building sites. In one run a clean and exact screed can be produced.
•
For the manual:
•
For the mechanical use:
The device consisting of the following components:
•
Telescopic aluminium screeding profiles, height adjustable roller units on either side, pulling elements.
•
Step board (for user) above the roller unit increase the pressure to the ground, when using mechanically.
•
Height adjustable roller units , including screeding rail wiper.
•
Accessories: adjustable adapter TAS-DP any roof or pan profile can be adjusted (+/- 4 % with scale) to prepare
any roof or pan profiles.
NON-PERMITTED ACTIVITIES:
Unauthorised changes to the device or the use of any self-made additional devices are a danger to
life and limb and are therefore strictly prohibited!
The nominal widths (working width) of the device must not be exceeded.
51000102
2 commercial shovels can be hooked in for pulling the device.
2 pulling chains for pulling the device.
5 / 18
GB