probst TAS-UNI-468 Instrucciones De Uso página 38

Assembly and adjustments
3.4 Adjustment of roller unit (Alu-Profile)
The working height (0-25 cm) of the device (TAS-UNI) can
be adjusted with the spindle (1).
•
Place the alu-profile direct on the facing bedding sand
(see fig.4).
•
Place the roller unit on the alu-profile.
•
Release the eyebolt (2).
•
Adjust the screeding profile on the crank (1) in that way,
that the screeding profile rests on the facing bedding
sand. Orientaion on the scale (3).
➔TIPP Optimal facing bedding sand (grit height) 2-3
cm.
•
Fasten eyebolt (2) again.
IMPORTANT
When using the AZL alu profile element as a
support element for roller unit, the following
must be noticed ➔ ➔ ➔
Roller unit
Facing bedding sand
51000102
Facing bedding sand
Fig. 4
AZL
(1)
(3)
(2)
Fig. 3
Roller unit
Alu profil element
Alu-Profile must rest on the
facing bedding sand.
14 / 18
Alu-Profile may not sink in the
facing bedding sand! 
GB