Publicidad
Idiomas disponibles
Idiomas disponibles
Assembly and adjustments
Measure the outer dimension at the TAS-UNI-DP (1) with a qualified measuring tool (6) e.g. yard stick (6) (or slide
gauge). This measure must be equal at the front side and back side (see ). → Figure 4 and Figure 5.
Tighten both nuts (2) again (tight) on the outer side at the TAS-UNI-DP. → Figure 6
Fig. 4
1%
Also a roof profile with different lengths of
aluminium profiles is preparable.
→ see Figure A1
51000102
Fig. 5
(1)
(6)
Figure A (roof profile)
Remessure the actual
slope at the facing
bedding sand
1 %
Fig. 6
(6)
Reference level
Figure A1
10 / 18
(2)
1%
1 %
GB
Publicidad
