Careand cleaning oftherange.
Receetade
S ]CKel
_
G6.35Bulb
/
Glass c over
(onsomemodels)
Glasscover
(onsomemodels)
Oven Light Replacement (onsome models)
A WARNINGSHOCK
oR BURN
HAZARD." Before replacing oven light bulb,
disconnect
the electrical power to the
4
range at the main fuse or circuit breaker
panel. Failure to do so may result in
electric shock or burn.
CAUTION BuRN
HAZARO
The glass cover and bulb should be
removed when cool. Touching hot glass
with bare hands or a damp cloth can
cause burns.
Toremove:
%
Turn
tile glass
cover
counterclockwise
:l/4
mrn
until
tile tabs of the glass cover clear
tile
grooves
of tile socket.
Wearing
latex
gloves
may of:let a better
grip°
[]
Using gloves or a (hT cloth, remove
tile bulb by pulling
it straight
out.
Toreplace:
[_
Use a new 120/130-volt
halogen
bulb, not to exceed
50 watts.
Replace
tile bulb with tile same type
of bulb that was removed.
Yo m
model will have one of tile two types
shown on tile lefL To demrmine
the correct
replacement
bulb, check
tile bulb mmlinNs.
Bulbs with 2
straight
pin terminals
are G6.35
bulbs. Bulbs with 2 looped
terminals
are G9 bulbs. (DO not
interchange.)
Be sure the replacement
bulb is
mmd 120 volts or 130 volts (NOT
12 volts).
%
Usegloves
or cloth
Using gloves or a dry cloth, remove
the bulb flom
its packaging.
Do not
touch
tile bulb with bare fingers.
Oil flom
skin will damage
tile bulb
and shorten
its life.
Push tile btflb straight
into tile
receptacle
all tile way.
Place tile robs of tile glass cover into
tile grooves
of tile socket. Turn
tile
gk_ss cover clockwise
:l/4 turn.
For improved
lighdng
inside die
oven, clean die gk_ss cover
flequen@
using a wet cloth. This
should
be done
when the oven is
complemly
cool.
Reconnect
electrical
power to
tile oven°
i ; il;ili
i! ill
I
[/ii
[:[
Wire cover holder
Oven Light Replacement (onsome models)
Be sure to let the light cover and bulb
cool completely:
Toremove the cover
Hold a hand
under
tile cover so
it doesnt fidl when xeleased. XA, lth
fingers of tile same hand,
firmly
push back tile wire cover hoMer
i JR off tile covex:
DO ROtremove ally screws to remove the cover
Toreplacethe cover:
Place it into groove of die light
receptacle.
Pull whe fbrward
to
tile cenmr
of tile cover until it snaps
into place.
_]
Connect
electrical
power to tile
xange.
Replace bulb with a 404,vatt
appliance bulb.
34