GE PGS908 Manual Del Propietário página 40

Before you call for service..,
Troubleshooting tips
Possible Causes What To Do
=
"F--and a number You have a function error code. * Touch the CLEAR/OFF pad. Put the oven back into
or letter"flash operadon.
If the function code repeats. • Disconnect all power to the range for at least ,'30
seconds and then reconnect power. If the flmction
error code repeats, ca/1 R_, service.
Control signals after
You forgot to enter a * Touch tile BAKE pad and desired temperature
or
entering cookingtime bake temperature or the SELF CLEANSTB/LOWor SELF CLEAN LOW/STBpad
or start time cleaning time. and desired clean time.
Oisplaygoes blank A fuse in your home may • Replace tile fhse or reset tile circuit breaker
be blown or the circuit
breaker tripped.
The clock is in the • See the Special features of your oven control secdon.
black-out mode.
Display flashes Power failure. = Reset the clock.
Unable to get the Oven control pads were = Tile BROIL HI/LO and BAKE pads must be touched at
display to show "SF" not touched properly, the same time and held for 3 seconds.
"Probe" appears in This is reminding you to • Enter a probe temperature.
the display
enter a probe temperature
after plugging in the probe.
Power outage, Power outage or surge. • Reset tile clock. If tile oven was in use, you must reset
clock flashes it by touching tile CLEAR/OFFpad, setdng the clock
and resetting any cooking fimction.
Steam from the vent When using the convection • This is normal.
feature, it is normal to see
steam coming out of the oven
vent. As the number of racks
or amount of food being
cooked increases, the amount
of visible steam will increase.
"Burning" or "oily"
odor emitting from
the vent
This is normal in a new oven
and will disappear in time.
• To speed tile process, set a self:clean cycle for a
minimum
of 3 hours. See the Using the self-cleaning
oven section.
Strong odor
An odor from the insulation • Tiffs is temporary.
around the inside of the oven
is normal for the first few times
the oven is used.
Fan noise
A cooling fan or a convection
fan (depending on the
function you are using) may
automatically turn on and off.
• This is normal. Tile cooling tim will mrn off and
on to cool internal parts. It may run after tlle oven is
turned OFE Tile convection fan will cycle on and off
until the function is over or tile door is opened.
£OC shows in the
The Range Lock-Out feature • Be sure the surface burner controls are turned OFF.
display
is activated.
Turn this feature off to use the range. See the
40 Range Lock-Out section.