Publicidad
Idiomas disponibles
Idiomas disponibles
Enclosure Configuration
5
Remove door handle using a Phillips screwdriver to remove the
three screws holding the handle in place.
6
Remove door bumpers and move them to the holes on the opposite
side.
7
Reinstall the door by reversing the steps 5 through 1.
8
Connect LCD: Remove the zip ties securing the cables to the rack.
Connect the COM 1 cable to the LCD, then connect the power
cable to the LCD panel. Bundle the excess cable together and
secure to the door with zip ties.
Note: Make sure to leave enough slack for the door to open fully without
putting stress on the connections.
5
6
Bumper
Bumper
Door Handle
Bumper
Bumper
7
13
Handle
Cover
Publicidad
