Whirlpool AKZ9 6240 NB Guía De Referencia Diaria página 2

ACCESSORIES
WIRE SHELF
MEAT PROBE
(ONLY IN SOME MODELS)
INSERTING THE WIRE SHELF AND OTHER
ACCESSORIES
Insert the wire shelf horizontally by sliding it across
the shelf guides, making sure that the side with the
raised edge is facing upwards.
Other accessories, such as the drip tray and the
baking tray, are inserted horizontally in the same way
as the wire shelf.
FITTING THE SLIDING RUNNERS (IF PRESENT)
Remove the shelf guides from the oven and remove
the protective plastic from the sliding runners.
To secure the guide, press
the lower portion of the
clip firmly against the shelf
guide. Make sure that the
runners can move freely.
Repeat these steps on the
other shelf guide on the
same level.
Please note: The sliding runners can be fitted on any level.
2
DRIP TRAY
Fasten the upper clip of the
runner to the shelf guide
and slide it along as far as it
will go. Lower the other clip
into position.
BAKING TRAY
The number of accessories may vary depending on which
model is purchased.
Other accessories can be purchased separately from the
After-sales Service.
REMOVING AND REFITTING THE SHELF GUIDES
. To remove the shelf guides, lift the guides up and
then gently pull the lower part out of its seating:
The shelf guides can now be removed.
. To refit the shelf guides, first fit them back into
their upper seating. Keeping them held up, slide them
into the cooking compartment, then lower them into
position in the lower seating.
SLIDING RUNNERS *
(ONLY IN SOME MODELS)