Bosch HDI8054 Serie Manual De Instalación página 19

Reinstalling the Oven Door
and Warming Drawer
4. The drawer has a "push-to-open" operation. Pressing
the front of the drawer inward causes the drawer to self
open.
Reinstall the oven door:
1. Hold the door firmly in
both hands.
2. Hold the door at a 30 °
angle from the closed
position and insert
hinges into the slots.
You may need to rock
the door forward and
backward slightly to
seat the hinge feet.
,
The door may need to
be removed and re-
inserted until the
hinges sit correctly in
the slots.
4. Open door all the way
to expose hinges,
levers, and slots.
5. Push levers forward
and down until seated
on the bracket.
,
Close and open door
slowly to be sure it is
correctly and securely
in place. Door must be
straight, not crooked.
Reinstall the Warming Drawer.
,
2.
,
Be sure cabinet rails are pushed inside cabinet.
Align the rails on the drawer rails with the rails attached
to the drawer housing.
Firmly push the drawer straight into the drawer housing
until the drawer clicks into place. The drawer should
insert easily. If it binds, do not attempt to force it.
Remove the drawer, align the slides on the housing to
the front edge of the housing and try again. Slide the
drawer into both housing slides at the same time, and
keep the drawer level while doing so.
5. Open and close drawer to test operation. Note: if the
drawer will not close, verify that the rail release levers
are properly positioned.
Testing Operation
Test the Oven
1. Turn on power at the breaker.
2. Test the oven mode.
Select the BAKE mode. See the Use and Care Manual
for detailed operation instructions.
3. Verify that the oven light comes on and the oven begins
to preheat.
4. Test the door lock.
Set the SELF CLEAN mode. Confirm that the door
locks when the lock icon appears in the display.
5. If any of the tests do not result as explained above,
contact Bosch service for assistance. Otherwise,
continue with testing the rangetop burners.
Test the Rangetop Burners
Each burner must be tested for proper lighting, proper
flame characteristics on the low setting and proper flame
characteristics on the high setting.
Test for proper ignition:
1. Push down and turn the knob to the flame symbol.
2. Verify that the ignitor/spark module clicks.
English 17