Publicidad
Idiomas disponibles
Idiomas disponibles
en-us Installation and connection
Aligning the drawers
You can align the drawer vertically:
Open the drawer as far as it will go and remove
1.
the bottle shelves.
Remove the cover cap on both sides.
2.
10
Loosen the upper screw on both sides.
3.
Do not remove the screws.
Note:
Lift the drawer and remove the lower screw on
4.
both sides.
Move the drawer up or down to the required
5.
position and screw the lower screw into one of
the available holes.
The drawer can be adjusted by 1/16"
Note:
(1.6 mm) up and down.
Tighten all screws again and put the cover cap
6.
back on.
To check the position, close the drawer and
7.
correct if necessary.
Publicidad
