Descargar Imprimir esta página

Onkyo TA-2090 Manual De Instrucciones página 9

Ocultar thumbs Ver también para TA-2090:

Publicidad

Idiomas disponibles

Idiomas disponibles

Trouble-shooting Guide
(see page 7).
Rec button does not engage.
@No tape in cassette compartment.
@ Load cassette tape.
e@Erasure prevention tab(s) punched
@ Change tape or cover tab hole with
out.
adhesive tape.
Hoarse sound, balance
Playback head dirty.
®Ciean head (see page 8).
unstable.
® Tape is stretched.
@ Replace tape.
ar
Extensive noise and tape
® Head has become magnetized.
®Demagnetize
(see page 8}.
hiss,
High
noise level tape.
© Replace tape.
Playback distortion.
® Distortion in tape.
® Recorded tape is probably bad, but
confirm by changing tapes.
® Readjust Output Level control.
*Output Level control set too high.
e Readjust master input recording level control
according to the directions on page 6.
Recorded sounds are
distorted.
® Recording is done at too high a
level.
Tape squeal and skipping.
® Dirty head, pinch roller, or capstan
shaft.
®Tape cassette is binding.
®Clean (see page
8).
®Try correcting with Fast Forward and Rewind.
Excessive
playback
hum.
®Connecting cords not inserted
firmly.
External! flux leakage from nearby.
® Insert plugs firmly.
®@Move deck away from hum source.
High frequency sounds strong.
| @ Dolby NR and dbx encoded. tape
played back with NR selector set at
a position other than the proper
Dolby or dbx position.
@Set NR selector to proper Dolby position or dbx
(Dolby B, Dolby C or dbx depending on which
was used for recording).
® Automatic tape selector not set to
correct
position.
© Confirm that cassette has detection holes.
No high frequency sounds.
e NR selector set to B or C position
during ptayback of tape recorded
without Dolby noise reduction.
®@ Set Dolby NR selector to proper position for tape
being played back,
If no noise reduction system
was used when recording the tape, set
NR selector
to out position.
Clean (see page 8).
@ Record and/or playback head has
become dirty.
Timer
recording fails to operate;
switches automatically to timer
®Erasure prevention tab has been
punched out.
® Change tape Or cover tab hole with
adhesive tape.
playback.
The AMCS
or single repeat
e@ The blank sections between songs
e Use a cassette with blank sections of sufficient
function does not operate
are too short or contain too much
length between
songs.
Properly.
noise.
:

Publicidad

loading