Mitsubishi Electric PLFY-WL-NEMU-E Serie Manual De Instrucciones página 17

3. Operation
3.8. Mode Selection (For Simple MA remote controller)
Pressing the MODE button will change the operation mode in the following order.
*1 *1
COOL DRYING FAN
*1: Not all functions are available on all models of indoor units. Functions that are not available will not appear on the display.
*2: The preset temperature for AUTO (either single or dual set point) mode will appear depending on the indoor unit model.
AUTO (dual set point) mode:
In AUTO (dual set point) mode, the preset temperatures can be set for cooling and heating, and operation can be switched automatically between
cooling and heating depending on the room temperature.
The preset temperatures for cooling and heating set in AUTO (dual set point) mode will be refl ected to the temperature setting for COOL/DRYING
and HEAT modes.
During operation in AUTO (dual set point) mode
Preset temp.
(COOL)
Preset temp.
(HEAT)
HEAT
SETBACK mode:
The SETBACK function automatically switches the operation mode between cooling and heating to maintain the room temperature within the set
temperature range.
The preset temperatures for cooling and heating set in SETBACK mode can be diff erent from the preset temperatures for other modes.
During operation in SETBACK mode
Preset temp.
(COOL)
Preset temp.
(HEAT)
HEAT
*1, *2 *1 *1
AUTO SETBACK HEAT
The room temperature
changes corresponding
to the change in the
outside temperature.
COOL HEAT
The room temperature
changes corresponding
to the change in the
outside temperature.
COOL HEAT
Room
temperature
COOL
Room
temperature
COOL
en
15