Publicidad
Saw
Operations
Crown Molding Angled to Table
and Fence
The advantage to cutting in this position is that no bevel
setting is required. Cutting is done with 45 ° miter angle.
Crown molding of up to 6-5/8" maximum width can be
cut on your saw.
Sliding Fence
Follow these instructions for cutting crown
moldingangled to table and fence.
1.
2.
3.
Position
the molding
so the bottom
(part which
is
installed against the wall) is against the fence. Make sure
the sliding fence is in place to provide maximum support
(see Sliding Fence for instructions).
NOTE: Crown
Molding
Support
(accessory
#80163)
assists in holding crown molding
in place during the
cutting
operation.
Refer to the accessory
instruction
sheet for details. See page 74 for a complete accessory
list.
Set the miter angle using the chart below.
Tighten the
miter lock knob (Figure 34).
Activate the switch.
Lower the head assembly and make
your cut.
CrownMolding
Snpp0rt
450Miter
4.
5.
Wait until blade
comes
to a complete
stop before
returning head assembly to the raised position
and/or
removing workpiece.
ALWAYS
TAKE A TEST
CUT
USING
SCRAP
TO
CONFIRM CORRECT ANGLES.
CROWNMOLDINGCUTS ANGLED TO TABLEANDFENCE
U.S.STANDARDCROWNMOLDING
52 ° CEiLiNG
MAXIMUMSIZE: 6%"
TABLE
ALL CUTS= PLACEBOTTOMEDGEAGAINSTFENCE
TYPE
MITER
BEVEL
OF
(TABLE)
(TILT)
LEFTSIDE 0 _
RIGHT
SAVE RIGHT END OF CUT _
o
ll_
0
RIGHTSIDEO _
LEFToII_
O0
SAVE LEFT END OF CUT
LEFTSIDE 0
SAVE RIGHT END OF CUT
RIGHTSIDE0
SAVE LEFT END OF CUT
LEFT
Oo
RIGHT ol _
Oo
Chart 2: Crown MoldingAngledto Table andFence
69
Publicidad
