Publicidad
Basic
ToEngage:
Saw
Operations
Detent Override
1.
Lift the miter detent trigger 1 (Figure 27).
2.
Push the detent override clip 2 forward and latch in place
over edge. Release miter detent trigger 1.
3.
Move miter arm 3 to any position on the miter scale.
4.
Lock the miter lock knob 4 to retain miter position.
ToDisengage:
5.
Loosen miter lock knob 4 and lift the miter detent trigger
1 to release the detent override clip 2.
Sliding Base/Fence Extension
_'vl
II-],,==,,r=.==
ir :_VAV.,___LXL,,,L,L_ Extend and use sliding base/fence
when making severe bevel, severe miter or compound
cuts
to provide sufficient (minimum 6") spacing from hand to saw
blade.
Sliding Base:
...
0
4
1.
2.
3.
4.
Remove hex wrench from storage position on left rear
leg.
Loosen two (2) socket cap screws 5 in sliding base
channel (Figure 28).
Extend sliding base/fence 6 to the desired position.
Tighten screws. Store hex wrench.
6
5
Sliding Fence:
1.
Unlock the fence locking lever 7 (Figure 29).
2.
Slide fence to proper position 8.
3.
Relockfence
in place.
rr_[#,__lJ/[,]:m
During transportation,
sliding base
and fence should always be secured in the full in position.
8
7
/
)
54
Publicidad
