Publicidad
Adjustments
Disconnect plug from power source
before performing
any assembly,
adjustment
or repair to
avoid possible injury.
NOTE: Your compound miter saw was completely adjusted
at the factory.
However,
during
shipment,
slight
misalignment
may have occurred.
Check the following
settings and adjust if necessary prior to using this compound
miter saw.
1.
2.
Blade Square to Table (90 °)
Rotate table 1 to 0° position and lock in place.
Lower the blade 2 and engage the lock pin 3. Use a
combination
square 4 to check blade squareness
to
table. Place the square on the table and press it against
the blade. If the blade does not contact the full length of
the square, (Figure 6) follow the alignment procedure.
90 °
a.
b.
C.
d.
e.
f.
g.
B/ade A/ignment
Move sliding fence to proper position. (See Sliding
Fence on page 54.)
Loosen bevel lock handle 8.
Lower 0° stop screw and jam nut using blade
wrench supplied in the handle.
Grasp carrying handle, move the head assembly
left or right until blade makes contact with the full
length of the square.
Tighten bevel lock handle 8.
Adjust 0° bevel stop screw 5 so that the hex screw
head hits the 0° stop 6 at the same time the blade
makes contact with the full length of the square.
Tighten jam nut 7 (Figure 7).
Adjust bevel indicator 9. Loosen screw 10 and align
indicator
11 to the 0° mark. Tighten
screw
10
(Figure 8).
|
3
\
2
10
II_[€-]1_]
\
11
34
Publicidad
