Descargar Imprimir esta página

Troy-Bilt E189 Manual Del Operador página 11

Publicidad

Idiomas disponibles

Idiomas disponibles

Side Discharge Chute
To convert to side discharge, make sure grass catcher is off of the
unit, the rear mulching baffle is in place, and rear discharge door
is closed.
1.
On the side of the mower, lift the mulching plug.
2.
Slide chute hooks under hinge pin on mulching plug
assembly. Lower mulching plug. See Fig. 3-7. Do not
remove side mulching plug at any time, even when you are
not mulching.
Figure 3-7
Adjustments
Cutting Height
1.
The cutting height adjustment lever is located above the
rear left wheel. See Fig. 3-8.
Figure 3-8
a.
Pull the lever out and away from the mower.
b.
Move the lever forward or back for desired cutting
height.
c.
Release lever towards mower deck.
Set-Up
Gas and Oil Fill-Up
Refer to the separate engine owner's manual for additional
engine information.
1.
Add oil provided before starting unit for the first time out
of the box.
2.
Service the engine with gasoline as instructed in the
separate engine owner's manual.
WARNING:
Use extreme care when handling
gasoline. Gasoline is extremely flammable and the
vapors are explosive. Never fuel the machine
indoors or while the engine is hot or running.
Extinguish cigarettes, cigars, pipes and other
sources of ignition.
3.
Charge battery as instructed in the Service section of this
manual (Electric Start Units).
s
ectiOn
B
A
C
3 — a
& s
-u
sseMbly
et
p
11

Publicidad

loading