Publicidad
Idiomas disponibles
Idiomas disponibles
HOW TO USE
Before use, check appliance for visible damage. DO NOT USE THIS HEATER if there is evidence of damage. If any damage is found, contact
Vornado Air LLC at 1-800-234-0604.
1. Use the integrated handle on the back of
heater for lifting and carrying.
2. Position the heater so airflow is
not obstructed.
3. Plug power cord into a standard
120V/60hz wall outlet. Do not use with a
power strip. Ensure plug fits firmly into
the outlet.
COOL DOWN
When you power off your heater, it
automatically enters a cool-down
routine in which the heating element
turns off and the fan exhausts
remaining heat. During Cool Down,
the display counts down from three,
then powers off completely.
10 English
4. Press the power button
and select a Mode
.
Next, set thermostat to desired temperature using
-/+. To use as a fan year-round, use the Mode button
to select Fan Only. FA will appear on the display.
The fan will run continuously on high speed if in
Continuous and on low speed if in Auto.
Continuous
On High and Low heat, select Continuous Fan
and the fan will run continuously. Once in continuous
mode, the + and - key will only display CH
(Continuous High) or CL (Continuous Low).
Auto
On High heat, select Auto Fan
to allow both the
fan and heat output to vary. On Low heat, the fan will
always maintain low fan speed.
Set timer to automatically power heater off by
pressing
. The red indicator light above "timer on"
will illuminate red when the timer is in use. Press
to select the amount of time in one-hour intervals, up
to 12 hours. To cancel the timer operation, select 0
hours.
CLEANING
Because your heater moves a substantial amount of air, it will need regular cleaning. Cleaning the outside of the heater is recommended on a
weekly basis to remove dust accumulation. If service is required, return your heater to Vornado. See WARRANTY for instructions.
1. Unplug heater before cleaning.
2. Use brush attachment on your
household vacuum cleaner to
vacuum any accumulated dust
off Air Inlets located on sides
of heater.
You should periodically blow
out the heater with pressurized
air to keep heat element and
motor clear of dust, hair and debris
that can build up inside the heater
as it moves air during use. This also
eliminates unwanted odors caused
by accumulation of these particles
inside the unit.
3. Use brush attachment on your
household vacuum cleaner to
vacuum any accumulated dust off
the Front Outlet Grille.
4. Wipe down entire heater with a
soft, dry cloth.
Note: Do not modify the product
with any aftermarket accessory.
11
English
Publicidad
