Publicidad
Idiomas disponibles
Idiomas disponibles
STORAGE
During the off-season or after extended periods of non-use, you may
choose to store your heater. To ensure long life of the product, it is
recommended to store your heater by following these instructions:
Cleaning is recommended before storage.
1. Unplug power cord and
bundle loosely.
2. Cover, or place back in retail carton if
available. This will prevent the heater
from accumulating dust overtime.
3. Store heater in a cool and
dry location.
DISPOSAL
Dispose of all packaging
materials in an environmentally
responsible manner.
12 English
RESET HEATER
RESETTING YOUR VORNADO HEATER
Your Vornado Heater has a multilevel safety shut-off system designed
to prevent overheating. Overheating may occur when the inlets or
outlet are blocked. If this happens, the safety shut-off system will cut
power to the heater and you will need to manually reset the heater.
1. Power heater off, then unplug power cord. Make sure unit is on a
flat, level surface and ensure that it is not covered in any way.
2. Remove any obstructions.
3. Wait 5–10 minutes, allowing heater to cool down.
4. Plug in power cord and place heater in desired position.
5. Press power button on. Your Vornado heater should now
function normally.
Note: If the safety shut-off system
repeatedly shuts off your heater or if it
will not reset after following the above
procedure, call Vornado Consumer
Services Department toll-free at
1-800-234-0604.
TROUBLESHOOTING
PROBLEM
POSSIBLE CAUSE AND SOLUTION
The Unit fails to power on.
Unit is not plugged in. Plug power cord into electrical outlet. Ensure a tight fit between plug and outlet.
See IMPORTANT SAFETY INSTRUCTIONS.
Household circuit breaker has tripped or blown fuse. Reset circuit breaker or replace fuse. See
IMPORTANT SAFETY INSTRUCTIONS.
Ground fault circuit interrupter (GFCI) has tripped. Ground fault circuit interrupters are not recommended
for use and may cause nuisance tripping. If tripping does occur, relocate the unit to a standard wall outlet.
The unit has overheated. Automatic Safety Shut-Off has initiated. See RESET HEATER.
This unit features an internal tip-switch that activates and will shut the unit off if the unit tips over. Ensure unit
is on a flat, horizontal surface.
Unit is damaged or in need of repair. Cease usage and unplug. Contact Consumer Service for assistance.
The Unit is not producing a
Ensure unit is set to High Heat and thermostat is set to highest temperature setting.
sufficient amount of heat.
Switch unit to continuous heat mode.
Close all doors and windows to trap heat.
Allow the unit to fully circulate the heat throughout the room; may take several minutes.
13
English
Publicidad
