SKF TKBA 11 Instrucciones De Uso página 12

5. Power on
To turn the laser line on, use the main red switch located on the front of the
transmitter unit.
6. Alignment condition check
The laser line on the three passive targets show the vertical angle
misalignment, parallel misalignment or offset. Horizontal angle misalignment
is indicated by the offset position of the laser line on the three passive targets
with the same distance.
Before aligning the pulleys or sprockets, it is important that the pulleys
or sprockets are mounted correctly on the shafts and that the shafts
are straight.
Buckled pulleys will have a detrimental effect on the alignment quality.
7. Correcting misalignment
Display of vertical angle misalignment
Display of parallel misalignment
Fig.4 – Correction misalignment using actual targets
10 EN
Display of horizontal angle misalignment
Display of all three misalignments
combined