DEPTH OF FIELD
Depth of field can be checked with the white indicator engraved on the lens barrel.
If your camera has a depth-of-field preview function, it is possible to check the depth of
field in the viewfinder. (For details, see camera instruction manual.)
Depth of field can also be checked by referring to the table on pages 50-51.
USING FILTERS
Always use a filter with the lens. The slip-in glass filter holder comes mounted with a
Nikon NC filter. A slip-in gelatine filter holder is also supplied with the lens. Use L37C
filter to cut ultraviolet rays and slip-in circular polarizing filter C-PL1L to cut unwanted
reflections of non-metalic surface such as glass or water.
Replacing glass filters
Illust. B, C, D
1. Press down on the glass filter holder knob, and turn counterclockwise until the white
line on the knob is at a right angle to the axis of the lens.
2. Pull the holder out.
3.Unscrew the mounted filter and replace with the filter you want to use.
4. Put the holder back, push down on the knob, and turn clockwise to lock.
Using gelatine filter
Illust. E
1. Cut the gelatine filter into a circle of approx. 55mm (2.2 in.) in diameter.
2. Open the gelatine filter holder plate by pushing on the latch and lifting up.
3. Insert the gelatine filter into the holder and close the plate. Make sure the filter is
unscratched and free of dust and take care that it stays flat.
4. Remove the glass filter holder from the lens and insert the gelatine filter holder.
USING THE LENS HOOD HK-22
must F
When shooting in bright sunlight, use the lens hood to prevent stray light from entering
your lens.
1. Loosen lock screw on the HK-22.
2. Slip the HK-22 onto the front of the lens.
3.Tighten lock screw.
To Store the Lens Hood
Loosen lock screw on the HK-22. Reverse the HK-22, then slide back onto the lens and
tighten the HK-22 lock screw.
Standard Accessories
Slip-on leatherette front lens cap
Rear lens capLF-1
52mm screw-in filter NC
Holder for gelatine filters
Strap
Lens hood HK-22
Hard case CL-300
17