Reach into the rail with one finger and change the position of the lever by pressing the lever.
Hold this new position of the lever appropriately on both sides of the shelf and then pull out
the shelf.
Installation of the shelves:
Put the shelf back into the rail and slowly push it in until it clicks into place.
► Ensure that the shelves are firmly engaged in place before storing any bottles.
► Spread your bottles out as evenly as possible over the shelves.
12.5.7
Storage of bottles
Warning
► Do not store bottles crosswaves on the
interior floor! Otherwise, bottles may fall
out when the appliance door is opened
and this may cause injury or material damage.
12.6 Electrical connection
In order to ensure the safe and trouble-free operation of the device, the following instructions
must be observed for the electrical connection:
Before connecting the device, compare the connection data (voltage and frequency) on
the rating plate with those of your electrical network. This data must agree in order that no
damages occur in the device. If in doubt, ask your qualified electrician.
The connection between the device and the electrical network may employ a 3 meter long
(max.) extension cable with a cross-section of 1.5 mm². The use of multiple plugs or
gangs is prohibited because of the danger of fire that is involved with this.
Please note
Example:
for 750 ml Bordeaux bottles
Total: 18 bottles
38