Publicidad
Idiomas disponibles
Idiomas disponibles
Make sure that the power cable is undamaged and has not been installed under or over
hot or sharp surfaces.
This device is not designed to be installed in an RV or used with an inverter.
The electrical outlet must be protected by a 16A safety cut-out switch.
The electrical safety of the device is only guaranteed if the device is connected to a
properly installed protective conductor system. If in doubt, have the house installation
checked over by a qualified electrician. The manufacturer cannot be made responsible for
damages that are caused by a missing or damaged protective conductor.
13 Operation and Handing
This chapter provides you with important notices with regard to operating the device.
13.1 Operating elements and displays
The device transmits the following signal sounds as an acoustic feedback signal:
► Use the buttons
► Temperature recommendations: Red wine: 12°C – 16°C and white wine 6°C – 10°C.
► The device can achieve the best cooling and consumption results at a recommended
ambient temperature of 16-20 °C.
If you press the power button the device starts working.
With pushing both
exchange between °C and °F.
You can set the temperature as your desire: With
temperature by 1°C among 5-20°C.
You can tune the interior light on or off by pressing the "Light" button. The light will
switch off automatically after 4 hours to save energy.
The temperature in the device depends on the room temperature, the quantity of bottles and
the chosen temperature. Please note that your device is intended to cool wine. The
maximum temperature that can be reached inside the device cannot be significantly ABOVE
the ambient temperature at the setup location.
Please note
and
to set the temperature in the range of 5-20°C.
and
for 5 seconds, the temperature display mode will be
and
you can adjust the
39
Publicidad
